I just installed mine and they don't cover that lower groove that goes along the bottom of our doors and fender. Did your side skirts cover that groove or are they just below them like mine?
#8187, "RE: Everyone w/ Blitz Type II sides" In response to Reply # 0
umm not sure exactly what you are saying...but did you drill screws under where the door opens? There is like a less than half inch strip of metal that sticks out, and your side skirts should go over that, so you can drill 2 or 3 screws that are only visible when the door opens.
#8188, "RE: Everyone w/ Blitz Type II sides" In response to Reply # 1
I am talking about that little groove that the factory sides go up to and the the door cap would go up to. Well the top of my skirt is just below that groove and was wondering if thats how eveyone eles were.
#8189, "RE: Everyone w/ Blitz Type II sides" In response to Reply # 1
And Marcus, i don't know how you screwed your sides under your door without letting the screws show. I can see mine. How did you get them like that. The Carisma Blitz type I sides were much easier to install.
#8190, "RE: Everyone w/ Blitz Type II sides" In response to Reply # 3
Hey Ian, it "should" line up with the groove that the factory door caps and stock side skirts go up to. It might be slightly under it, like under 1/4" inch. The driver's side required a little bondo. And T&L installed my sides so I'm not sure how they go the screws to not show. I know they had to drill at an angle though...
Search
Printer-friendly copy
3 Users in Chat
