What is the best way to hook up 97-99 oem fog lights on a 99rs? Should I wire them to the driving lights, sidmarkers or what? Just wondering since their isnt a plug or harness that came on my rs for them.
Shawn 99 Eclipse RS Hahn Stage 2,Full built bottom end with je 8:8 and eagle rods ect..
#81278, "RE: Hooking up 97-99 fog lights" In response to Reply # 0
i run them off my parking lights. in all actuality i SHOULD and will do it right later on by wiring up a seperate relay for JUST the fog lights like the stockers have. you could use a switch or use the voltage from any of the lights to trip the relay. i personally drive with my fogs on all the time...and dont have a switch to turn them off since our headlights are so dim.
#81432, "RE: Hooking up 97-99 fog lights" In response to Reply # 2
Originally posted by bedlam32570 i have actually wired my aftermarket fog lights to the factory switch then tapped into the headlight low beam.
huh? so they are tapped into the low beams for power and off when you hit the high beams and they use the stock switch? Did you have oem foglights before and switch to after market foggers? OR is that just how you rigged it up (bought the switch from a foglight factory installed gs or something.)
Because I want to put foglights on my RS but never had stock ones but I DO have the switch that I bought off a parts car and its connected throught the harness there. The only reason I bought the switch panel is that that side of the dash looked so empty.
AIM - scirio
Originally posted by a drunk DSMRoadster drink now and nafter goddanti! celebaeration birches!
#81447, "RE: Hooking up 97-99 fog lights" In response to Reply # 3
i have an RS too. i did like you said. instead of using the switch i got with the foglights, i bought one from the dealer and go the wiring harness from a junkyard. the power wire for the foglights is tapped into my low beam wire from me headlights and boom. they act like the factory fog lights. even mounted in the same location.
#81500, "RE: Hooking up 97-99 fog lights" In response to Reply # 4
So if anyone could make a write up on the exact parts to get off of the donor car. and where to wire them in so they will work with the factory switch and not with the low beams, that would really be helpful.
#81526, "RE: Hooking up 97-99 fog lights" In response to Reply # 5
i'll go ahead and tell you what you need to get tomorrow i'll look and see what wires i hooked up where. it's late tonight and i have to be at work at 6 so i'll make it quick.
#81533, "RE: Hooking up 97-99 fog lights" In response to Reply # 6
I'm in suspense!!!
I just ordered my 97-99 factory foglights so I'll be waiting. When you say pigtails that means the harness from the foglight or the one from the car to the foglight. Thanks and I will be waiting for the write-up.
#81534, "RE: Hooking up 97-99 fog lights" In response to Reply # 7
I have the hahn fmic on mine and it looks like it would be a pita to put the right one on where in intercooler piping runs. Is there any modification needed?
Shawn 99 Eclipse RS Hahn Stage 2,Full built bottom end with je 8:8 and eagle rods ect..
#81535, "RE: Hooking up 97-99 fog lights" In response to Reply # 8
Never dealt with OEM fogs, but the simplest way to do this would be (assuming a two wire lead from each light) to run the two ground wires together and to a common ground on the chassis. Then you jsut need some switched power to run them. Of course, if there is a relay involved (which there should be) you're going to have to count on one of these guys to help you out, as I don't have the time right now. I wonder if you could get a replacement fog light harness with the relay from Autozone or something and just install the harness to your own lights?
#81549, "RE: Hooking up 97-99 fog lights" In response to Reply # 9
ok here we go hopefully I can explain this without pictures but I'll get some taken once I get my camera back.
The pigtail I was referring to is the one that you'll have to get from a donor DSM from the factory foglight switch. On that pigtail you'll see 4 wires set up something like this
wire 3 and 4 are for hooking up the light but I haven't done that yet. I'm kinda lazy about it.
wire 1 (green/black wire) will hook up to the factory headlight wires. if you have access to the underside of the headlight you'll see the plug for the headlight and the plug from the car. tap into the red wire on the one from the car.
wire 2 (green/blue wire) this will come from the foglight harness. the main power wire from the foglight harness will be spliced into wire 2.
hopefully i explained it. i'll take some pics once I get my camera back. sorry it sucks no being able to show this. hope this helps. you can reach me by email if you have more questions. I can check that at work alot easier than trying to get on here.
When I looked into the under hood fuse box I could see that there were no wires going into the foglight relay hole but I was able to connect the switch because the dash was factory pre-wired for them. I don't know what else to get in order for these things to work. I do not want to do a custom install because I like it to be factory wired becuase it always works better that way. I have not checked the fuse box in the car to see if it was pre-wired or not yet. Also my brakets that mounted between the foglights and the front end brace are bent so I just removed them and mounted them straight to the brace, do you people think that will matter. Thanks and I might not have included all the details so feel free to ask.
Search
Printer-friendly copy
1 User in Chat
