#7083, "RE: illuminated washer sprayers??" In response to Reply # 0
NO NO NO! dont get them! The cheap plastic crome will come oof and they look retared at night. Looks like your car has nostrils. However, if you want people to look at your car at night, get them. They got my attention. Just my $.02
#7086, "RE: illuminated washer sprayers??" In response to Reply # 4
In the Houston area you can get them at ASAA racing for about $20 a pair!!!
You can get pulled over for them?
Oh... I rememeber seeing them on a website, when I remember which site, I will post the site. I think they were selling them for about 40 bucks a pair.
#7087, "RE: illuminated washer sprayers??" In response to Reply # 5
I've driven by/in front of/along side cops in Irvine, Tustin, Santa Ana, Lake Forest (basically all of the Orange County area) and have yet to be pulled over. Mine are BLUE too, which is one of the colors they say will get the most attention because it may appear to some people that you are an emergency vehicle. I got pulled over for red front turn signals and I gots me a nice ticket for just that, the cop also said blue isn't legal, but I don't give an F.
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob STOLEN GReddy Shoulder Pads STOLEN Trust EVO Exhaust Front Upper Strut Bar Rear Upper Strut Bar H&R Sport Springs AutoMeter A/F Ratio Gauge Sony CDX610 ($400 Headunit) STOLEN 'tis it
#7090, "RE: illuminated washer sprayers??" In response to Reply # 8
i put blue stobes in my headlights. verry nice at night.
www.clubs.yahoo.com/clubs/eclipticrides mods: GS-T muffler pvc cai hotter spark plugs sticker on back mesh grill piaa plasma blue fog lights mesh over the rear center piece mods to come: turbo/nitrous/cyclone engine swap one of the three. eibach coilovers 17 in. white racing wheels custom exhaust body kit paint job wing ect.
#7091, "RE: illuminated washer sprayers??" In response to Reply # 9
I have them on th car. I had t cut the support under the hood to get the nut on the backside of the washer sprayer. it took a while to do. After all that, I wired them in with my aftermarket fog lighs, so I could cut them on or off with my fogs. I cut them off, then cut them on, then they burned out. I still have them on, because it looks pretty good anyways. Anyone have tips for installing them?
#7093, "RE: illuminated washer sprayers??" In response to Reply # 11
I got mine from Ebay, had to do the same thing as 9D9. You HAVE to cut the underside of the hood (not visible from outside) to fit the nut on the back of the sprayer. Yes you can still spray fluid with these. Wire them to your factory side markers, it's easy install all around.
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob STOLEN GReddy Shoulder Pads STOLEN Trust EVO Exhaust Front Upper Strut Bar Rear Upper Strut Bar H&R Sport Springs AutoMeter A/F Ratio Gauge Sony CDX610 ($400 Headunit) STOLEN 'tis it
#7095, "RE: illuminated washer sprayers??" In response to Reply # 13
It was a friggin pain in the ass, in fact there's still a lot of clean up work I need to do to completely finish. But I basically used VERY HEAVY DUTY tin snips and hacked away at it. I also predrilled a few spots to make it easier to get a clean cut, that also reduced the amount of material I had to cut away. Right now the expanded hole is pretty mangled looking, I still have to file down the endges of the hole because they're pretty damn sharp and jagged.
One thing I'm going to look into is this little tool people use to cut the fender when installing aftermarket side markers, it's called the ripper or cutter or something short and stupid like that. I think it's like a small hand held scissor like tool. I dunno.
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob STOLEN GReddy Shoulder Pads STOLEN Trust EVO Exhaust Front Upper Strut Bar Rear Upper Strut Bar H&R Sport Springs AutoMeter A/F Ratio Gauge Sony CDX610 ($400 Headunit) STOLEN 'tis it
#7096, "RE: illuminated washer sprayers??" In response to Reply # 14
My dad has a garage for his auto tranny biz. I pulled in there. We used an electric jigsaw. We put the blade in the hole that is already there. Then marked wit a pencil and cut the saw blade a little shorter than the mark to prevent bumping the hood. How cn you wire these into a fog light switch and them work>? I grounded and my fogs run off a 12 V, so I hooked them up, cut the lights on. They worked. Badass. Then cut the switch off. Then back on to check that they responded, and they blew. Who ever has these, can you help me out?
#7097, "RE: illuminated washer sprayers??" In response to Reply # 15
You know the orange side marker in the stock front bumper that everyone changes to clear? Well I wired it to that. The wires were JUST long enough.
Coo' 1997 RS AEM Cold Air Intake B&M Short Shifter Trust Shift Knob STOLEN GReddy Shoulder Pads STOLEN Trust EVO Exhaust Front Upper Strut Bar Rear Upper Strut Bar H&R Sport Springs AutoMeter A/F Ratio Gauge Sony CDX610 ($400 Headunit) STOLEN 'tis it
#7098, "RE: illuminated washer sprayers??" In response to Reply # 16
I might try that. I will get hiper white ones though. I had blue, and cops suck around here. I knew I would get pulled, so I wired to a switch, I guess it overloaded. Unless it has a transformer to increase voltage?
Search
Printer-friendly copy
1 User in Chat
