Can someone PLEASE post a ew up close and whole pics of the SPAL power window motor mounted in the door. I cant figure out this crap. -WILL

AIM - scirio

yeah, i would like to see a pic too since i just picked up one of those kits.

---------------------------------------------

They posted some pics of spal setups on here before just search and youll see them

Shawn
99 Eclipse RS
Hahn Stage 2,Full built bottom end with je 8:8 and eagle rods ect..

Here is the spal kit on my project talon. Let me know if you have any questions. I used gear #8 for the manual window shaft.

And the door panel fits over everything? What did you do about the crank shaft sticking out of the door in the panel. In the anual it says, no it SHOWS, that on some cars you can retract that shaft a bit, what did you do???

AIM - scirio

do you have any pics with the panels back on and the switches mounted?

Shawn
99 Eclipse RS
Hahn Stage 2,Full built bottom end with je 8:8 and eagle rods ect..

>And the door panel fits over everything? What did you do
>about the crank shaft sticking out of the door in the panel.
>In the anual it says, no it SHOWS, that on some cars you can
>retract that shaft a bit, what did you do???

door panel fits right on. you have to make sure the motor is towards the inside of the door and not sticking out. You can put spacers that they provided to move the crank shaft in a little bit. Plus you have the diffrent size caps that you can put over the hole in order to hide it. I dont' have pics of it installed but I did install it temporarily and it worked very well. I cut out holes with a dremel for the switches in the door panels where they would normaly go on a eclipse w/ power windows.