saw this on other ppls cars, decided to do it myself to free up a spot in my 2 pod A-Pillar (need one spot for a boost guage now)

Any thoughts?

looks nice. I've been looking for a spot to install an air/fuel gauge too (to lean the car out). How did you get your AC controls to glow blue, did you just change a bulb?

97 Eclipse GS
- Ebay CAI
- Ebay Dual Tip Muffler
- Ebay Front and Rear Strut Bars
- Energy Suspension Motor Mounts

yeap one bright blue LED, some people use 2 but I think 1 is just fine, please note its damn near impossible to see the red color of the "heat" controls.

I love my dremel

go to my site for the instrutions

"Only Pirates Say R"
hondahater21@hotmail.com
www.geocities.com/hondahater21

Change Your own Blinker Fluid! --> http://geocities.com/changeyourblinkerfluid/

wow. i like that. looks pretty cool dude

nice!

-----------------------------------------
2011 Nissan Xterra Pro-4x

2007 Kawasaki Ninja 650R

1996 Mitsubishi Eclipse RS-NX 75 shot, AEM CAI, P&P t/b and intake mani-SOLD

1964 Buick Electra 225-all original, all power options, 325hp, 445ft/lbs tq

Man I was thinking about doing that. Do you have a wright up or anything.

95 eclipse RS

14.80 @ 94mph with no turbo

That's where my Engine Start button is.

http://www.cardomain.com/ride/3130861

Im not sure it needs a write up. cut a hole where your cig lighter is and put the gauge in.

thanks for the feedback Im thinkin of putting the S-AFC next to it.
Ilove my dremel :p

>That's where my Engine Start button is.

i have never understood the point of push botton starter. don't you still have to put you key in and turn it so that your steering and everything else works?

dsm/mitsubishi service manuals https://www.mediafire.com/folder/5k14qlaulb9s1/dsm_mitsubishi

service manuals(my whole collection) https://www.mediafire.com/folder/ac51jwwa3g1n1/automotive_manuals

I use my cig lighter too much to do that.

Mods & Pix Here:
http://geocities.com/theplastik/

Cool guag

is there any gap around your gauge or were you able to have it mount flush. Very interested in this I need a place to put my EGT. Trying to keep a clean look.

there is just a tiny bit of white showing from the gauge towards the passenger side, I could paint the gauge black on thebottom or dremel towards the drivers side, but I already had everythign back together for a few days before I even noticed.

if you take your time and constantly check the fitment you can mount it flush, but remember its easy to take more plastic away, its impossible to add it back