saw this on other ppls cars, decided to do it myself to free up a spot in my 2 pod A-Pillar (need one spot for a boost guage now)

Any thoughts?

looks nice. I've been looking for a spot to install an air/fuel gauge too (to lean the car out). How did you get your AC controls to glow blue, did you just change a bulb?

yeap one bright blue LED, some people use 2 but I think 1 is just fine, please note its damn near impossible to see the red color of the "heat" controls.

I love my dremel

go to my site for the instrutions

wow. i like that. :thumbsup looks pretty cool dude

nice! :thumbsup

Man I was thinking about doing that. Do you have a wright up or anything. :)

That's where my Engine Start button is. :)

Im not sure it needs a write up. cut a hole where your cig lighter is and put the gauge in.

thanks for the feedback Im thinkin of putting the S-AFC next to it.
Ilove my dremel :p

>That's where my Engine Start button is. :)

i have never understood the point of push botton starter. don't you still have to put you key in and turn it so that your steering and everything else works?

I use my cig lighter too much to do that.

Cool guage:thumbsup

is there any gap around your gauge or were you able to have it mount flush. Very interested in this I need a place to put my EGT. Trying to keep a clean look.

there is just a tiny bit of white showing from the gauge towards the passenger side, I could paint the gauge black on thebottom or dremel towards the drivers side, but I already had everythign back together for a few days before I even noticed.

if you take your time and constantly check the fitment you can mount it flush, but remember its easy to take more plastic away, its impossible to add it back