do i need to drain the oil to install a oil pressure gauge. in the instructions included with my gauge it say i may need to but in the mods section it doesn't say anything about having to. i just wanna make sure i don't remove the OP switch and get a face full of oil. TIA

dsm/mitsubishi service manuals https://www.mediafire.com/folder/5k14qlaulb9s1/dsm_mitsubishi

service manuals(my whole collection) https://www.mediafire.com/folder/ac51jwwa3g1n1/automotive_manuals

Is it elec. or mech.? I have the elec. one and all I had to do was remove the stock oil psi. sender and and T it off with the autometer one. This can be a bitch because your pretty much working be feel and your reaching way up at the back of your engine.

Short Answer: If you have an Elec. one, NO. You don't have to drain your oil.

If your have the Mech. one then I don't know shit.

"Natty Ride"


http://dirty.thisfreedumb.com/

yeah its got an electrical sender unit that needs to be "T" with the stock sender.

dsm/mitsubishi service manuals https://www.mediafire.com/folder/5k14qlaulb9s1/dsm_mitsubishi

service manuals(my whole collection) https://www.mediafire.com/folder/ac51jwwa3g1n1/automotive_manuals

When I installed and uninstalled mine, a little bit of oil came out but it wasn't more than 1 oz or so.


________________________________________________________________________________________
Car Sold


http://hometown.aol.com/ohshootuhh/
www.Fast420A.com

Flame Red SRT-4 GT40,8.5:1 Built Shortblock, Brian Crower Stage 2 Cams, etc etc etc...