#35587, "RE: painting vents" In response to Reply # 0
try to grab them on the top and bottom. I have seen people grab the center part and break the bars. You have to pull the center console vents pretty hard. You can also tilt them and grab under them or on top and pull up or down and they will pop out.
#35588, "RE: painting vents" In response to Reply # 1
use a flathead. the center vents pop out from the sides and the door ones from the top and bottom. like 9D9 said, do not pull or put pressure on the bars cuz they will break.
#35590, "RE: painting vents" In response to Reply # 3
Yep, they pop right out of the center. Just be careful. The vents of the doors are screwed in from the back though and a real bitch to put back in without scratching!
Allan 2008 Magnetic Black 350z NISMO /1976 Austin Mini 1098 Special (export)
#35591, "RE: painting vents" In response to Reply # 4
yeah if u don't want to scratch it just put a rag around the screwdriver. the ones on the door i just took off the whole door panels and worked from there.
98 esi A/t: injen intake n1 muffler white gauges 17' adr sokodu's coilovers 1.75' drop obx front strut bar 3 stage metal headgasket (should of rebuilt bottem when this was done but I'm stupid)
98 esi A/t: injen intake n1 muffler white gauges 17' adr sokodu's coilovers 1.75' drop obx front strut bar 3 stage metal headgasket (should of rebuilt bottem when this was done but I'm stupid)
#35592, "RE: painting vents" In response to Reply # 5
i just took out the centers, just pulled on the top. They came out pretty easy. Then I took out the side vents. I put a screw driver under the vent and pryed up on it a little, it popped out easy and did the same with the top. Only took a couple of minutes, no damage done. thanks guys
Altezzas Clear corners AEM-CAI Red carbon fiber dash kit Reverse indiglo guages 17" Konig Verdicts 1.5 Din Alpine Deck CDA-D852
Search
Printer-friendly copy
0 Users in Chat
