anyone ever taken there seatbelts out? cus i need to take mine out to swap for 4 point harnesses... let me know if you have any pointers or if its hard, easy to do, thanks
Mike

1997 Mitsubishi Eclipse GS
My other ride is your girlfriend.

it aint bad, just have to have a breaker bar... if u have a chiltons, it shows u were the bolts are...

the hardest thing will be removing the plastic peice that covers the top part of the belt...

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki

not hard at all, its simple to find all the bolt points, then just use a 17mm i believe and just unbolt them.

-----------------------------------------
2011 Nissan Xterra Pro-4x

2007 Kawasaki Ninja 650R

1996 Mitsubishi Eclipse RS-NX 75 shot, AEM CAI, P&P t/b and intake mani-SOLD

1964 Buick Electra 225-all original, all power options, 325hp, 445ft/lbs tq

Basically, if u can install 4 points, u should be able to take out the belts. The rears, just take off the rear side panels and remove the lower part of the back seat by pulling the tabs on each side. Fronts, pry the caps off at the top, and then take the bolts out. After you find the part that retracts the belts, just remove the bolts, and slide it up and pull it out. Not very hard, just kinda tedious after doing the 1st 2.