| Go back to previous topic | | Forum name | Interior/Exterior | | Topic subject | removing seat belts.. need help | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i7&topic_id=33518 |
33518, removing seat belts.. need help
Posted by 97GoSlow, Nov-02-02 04:32 AM
anyone ever taken there seatbelts out? cus i need to take mine out to swap for 4 point harnesses... let me know if you have any pointers or if its hard, easy to do, thanks
Mike
|
33519, RE: removing seat belts.. need help
Posted by vegasdsmr, Nov-02-02 07:21 AM
it aint bad, just have to have a breaker bar... if u have a chiltons, it shows u were the bolts are...
the hardest thing will be removing the plastic peice that covers the top part of the belt...
|
33520, RE: removing seat belts.. need help
Posted by 96eclipse2nr, Nov-02-02 07:22 AM
not hard at all, its simple to find all the bolt points, then just use a 17mm i believe and just unbolt them.
|
33521, RE: removing seat belts.. need help
Posted by 9D9 MITSU RS, Nov-02-02 05:51 PM
Basically, if u can install 4 points, u should be able to take out the belts. The rears, just take off the rear side panels and remove the lower part of the back seat by pulling the tabs on each side. Fronts, pry the caps off at the top, and then take the bolts out. After you find the part that retracts the belts, just remove the bolts, and slide it up and pull it out. Not very hard, just kinda tedious after doing the 1st 2.
| |