Wasn't sure where this post should go. I have an oil temp gauge and was going to install it in the driver door vent(from the mods section)but where do i install the temp sensor at and what wire should i splice into to have it light up when i turn on my dash lights? TIA

"...you didn't have a chance,like my two aborted babies..."
UNDER CONSTRUCTION
http://www.streamlineracing.com

"...You're as dumb as an ox and twice as ugly. If a strange man offers you a ride, i say...take it..."
-Abe Simpson to little Homer.

1995 RS
CURRENT MODS:
Iceman CAI//Focuz cat-back exhaust//60mm Jeep TB//OBX short throw shifter//Symborski shift kit

Hey, you can follow the same steps for the oil press gauge in the mods section.

http://www.cardomain.com/ride/3130861

I don't see one for Oil temperature just oil pressure.

"...You're as dumb as an ox and twice as ugly. If a strange man offers you a ride, i say...take it..."
-Abe Simpson to little Homer.

1995 RS
CURRENT MODS:
Iceman CAI//Focuz cat-back exhaust//60mm Jeep TB//OBX short throw shifter//Symborski shift kit

Yeah I know, but you can install it the same way in the same place. You'll just be installing a temperature sensor instead of a pressure sensor. The fitting might be a different size though. You just need to find a source for oil that's all.

http://www.cardomain.com/ride/3130861

Ok cool, so my next question is if i wanted to install an oil pressure gauge too how would i do that since the temp sensor would already be in the place the press. sensor would go?

"...You're as dumb as an ox and twice as ugly. If a strange man offers you a ride, i say...take it..."
-Abe Simpson to little Homer.

1995 RS
CURRENT MODS:
Iceman CAI//Focuz cat-back exhaust//60mm Jeep TB//OBX short throw shifter//Symborski shift kit

I tapped my gauge illumination power and ground leads to my lighter illumination. Pretty simple.

Christian
06 GG IX MR SE
http://www.ichibanracing.com/ is DOWN!! In between hosts.