#8449, "those w/ prokits, did you use ingall kit 3585 or 3586"
There's a ton of info about prokits on this board, but I haven't seen a definative "this camber kit part# goes with prokits." I listed only the front camber kit #, but what about rear kit # did you chose as well?
While I'm at it, with the prokit being only like 20% stiffer than stock, can you even feel that? (in terms of comfort)
2gnt: '99 RS-T, killed by a toyota, pending rebuild... Daily: Volt Daily #2: '99 EVG ebike- STOLEN by PEDRO
#8450, "RE: those w/ prokits, did you use ingall kit 3585 or 3586" In response to Reply # 0
15 dolla camber mod on the mainpage under mods. Basically you get longer bolts, and stuff some washers between the fender and the control arm to bring it out to correct camber. For the drop with prokits, you really won't need to get the ingalls kit, it really is the same thing..
13.5 @108 MPH-2.2 60ft(stupid FWD!) S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential fuel injection) My webpage: http://eclipsed4evr.home.comcast.net -1998 Mitsubishi Eclipse RS-T- "Toy" -1992 Plymouth Laser Turbo AWD(SOLD) -2000 Honda CR-V(daily)
#8452, "RE: those w/ prokits, did you use ingall kit 3585 or 3586" In response to Reply # 2
>for real? thanks bro... it'll save me some money. so did >you have prokits before, cause it says you're running with >H&R's now
No, i never had the prokits, but the prokits drop you around 1.3-1.5 inches in the rear after settle, and my springs settled to about a 1.75" drop in the rear, and the 15 dolla camber mod just about put me in spec for my rear camber. I had to have 5 washers on the drivers side, and 6 on the passenger to get it in spec. With not as low of a drop, the required 4 washers on the mod page will be just about perfect with the prokits...
13.5 @108 MPH-2.2 60ft(stupid FWD!) S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential fuel injection) My webpage: http://eclipsed4evr.home.comcast.net -1998 Mitsubishi Eclipse RS-T- "Toy" -1992 Plymouth Laser Turbo AWD(SOLD) -2000 Honda CR-V(daily)
#8453, "RE: those w/ prokits, did you use ingall kit 3585 or 3586" In response to Reply # 3
I have the prokit and the $15 (which cost me $20! LOL!) camber mod. Works fine. Just make sure you get at least grade 8 bolts! Very important.
********************************** "Don't worry, I'm fluent in weirdo." Hurricane_GS eclipse@gcni.net AKA: Glenn H. Shelton III Saint Cloud, FL 1997 Eclipse GS Non-Turbo http://eclipse.greenliquid.com --------------------- Front Upper Strut Bar Rear Upper Strut Bar Custom Lower Front Tie Bar Custom Lower Rear Tie Bar AEM Cold Air Intake Pace Setter Muffler Custom Short Shifter (Only $40 - Email me for info! eclipse@gcni.net) Smoke Tinted Clear Tail Lights Custom Illuminated Center Tail Tokico Blues Eibach Pro Kit Neuspeed Front Strut Bar
Search
Printer-friendly copy
2 Users in Chat
