Current set up Eibach pro kit springs and 18 inch wheels. How many degrees of correction do I need to get back to factory specs?? Any input would be appreciated!

96 ESI, Eibach pro-kit, Iceman CAI, Greddy Cat-Back, MSD Ignition
Other rides:
92 Dodge Ram 4x4
96 Jeep Grand Cherokee 4X4
2004 Honda Civic EX
2002 BMW 325i
2008 Nissan Armada

Take it to a shop to see what degree its at right now. All cars repsond different.

------------------------------------------------
98 ESi
95 GS

I have prokits with 17s and I just did the $15 mod and it fixed it up just fine.

how thick are all the washers when put together? So I can get the right thickness.

96 ESI, Eibach pro-kit, Iceman CAI, Greddy Cat-Back, MSD Ignition
Other rides:
92 Dodge Ram 4x4
96 Jeep Grand Cherokee 4X4
2004 Honda Civic EX
2002 BMW 325i
2008 Nissan Armada

There were four washers on each bolt so that made it about an half to three-fourths of an inch thick I guess.
Hope this helps.

Thanks thats what I needed to know, did you get alignment after you done the camber adjustments, if so do you remember what your readings were?

96 ESI, Eibach pro-kit, Iceman CAI, Greddy Cat-Back, MSD Ignition
Other rides:
92 Dodge Ram 4x4
96 Jeep Grand Cherokee 4X4
2004 Honda Civic EX
2002 BMW 325i
2008 Nissan Armada

Glad I could help. Yeah you need to have it aligned when you put on the springs and the camber kit. I dont remember what my camber reading was after aligned but it is not bad. The guy said that the factory specs for the rear is around -1 degree(mine might have been like -1.2 degrees)
TIA

I'm about to order my springs, so do we need any kind of kit for the front with the Eibachs or will the factory hardware allow for the proper adjustments??? TIA!!!