Either tomorrow or this weekend I plan on finally lowering my car. I figure that I'll lower it anywhere from 1.5" to 2". I'm going to be using a hoist and was wondering if anyone has any ideas or experience with backing off of the thing and not getting the car hung up. I plan on putting one 2x6 on each side after I get everything on, but is there anything else that I may have to do or watch out for when using this thing? Any info would be greatly appreciated. Thanks.

HeDog

'95 Nstar White GS (AT) w/blue fade

Performance:
Iceman Cold Air Intake
Thermal R&D 3" Turbo Exhaust

Suspension:
Focuz RSII Dual Spring Coilovers
Tokico Blue Struts
Front Upper Strut bar

Exterior:
'99 Front & Rear Bumpers
Chrome/Clear Projectors
Catz Zeta 00 Headlight System
PIAA Platinum Low beams
PIAA 1100x Driving Lights
G2 Altezza Taillights
Clear Corners
3 Piece WW Midwing Spoiler

http://www.dsmtuners.com/gallery/showgallery.php?cat=500&ppuser=879

HeDog

'95 Eclipse GS/Turboed

HRC Stage II with FMIC.

You'll scrape around town anyway. Usually if its a drive on hoist we have to put little 2x4's there. And when its a hoist where you have to put 4 arms under the car and raise that I just have someone lift up my car a little bit so the hoist will fit under it.



ICQ #2199879
AOL - EvuLFleA
stillk@geocites.com

------------------------------------------------
98 ESi
95 GS