#20440, "RE: question about ignalls" In response to Reply # 0
I dropped on prokits and put the ingalls kit in the rear...but not the front. I did notice that the front tires were wearing a little faster than the rears...so it might be a good idea to pick up the kit.
#20445, "RE: question about ignalls" In response to Reply # 1
Yeah, a 0-1 degree front camber kit should be all you need, but you could probably get away without it for a while. For the rear that kit'll do just fine... it's essentially the same as the $15 camber kit mod.
I've been lowered around 1.8" for two years now and never used a front camber kit until only recently when I bought new wheels. I found out my front camber was around 1.25 degrees so I bought a 1.25-3 degree kit. For the rear I used the $15 camber kit mod with 6 washers and it was right in spec.