im only dropping like 1.5 at most (tokico blues w/prokits)so is this the right part...
http://www.iapdirect.com/item.asp?invid=66

and will i need a kit for the front? thanks

I dropped on prokits and put the ingalls kit in the rear...but not the front. I did notice that the front tires were wearing a little faster than the rears...so it might be a good idea to pick up the kit.

Yeah, a 0-1 degree front camber kit should be all you need, but you could probably get away without it for a while. For the rear that kit'll do just fine... it's essentially the same as the $15 camber kit mod.

I've been lowered around 1.8" for two years now and never used a front camber kit until only recently when I bought new wheels. I found out my front camber was around 1.25 degrees so I bought a 1.25-3 degree kit. For the rear I used the $15 camber kit mod with 6 washers and it was right in spec.