Will it work ok to have the AGX's al front and rear with prokits?? I have read about issues with the front if you lower too much but I am not really "slamming" it with prokits so I was thinking it would work just fine....


Thoughts/Comments/Pictures????

All is welcome,...

TIA

Chad

MODS:
3" PVC CAI, GST Muffler, Greddy 4-1 Header, AFX UDP, 55 mm bored TB, P&P Intake Manifold, Corbin intake spacer, gutted cat, Apexi S-AFC, KYB AGX Struts, Eibach Prokits, Excel TZ-10 Rims

Bumpitty....NE1??

MODS:
3" PVC CAI, GST Muffler, Greddy 4-1 Header, AFX UDP, 55 mm bored TB, P&P Intake Manifold, Corbin intake spacer, gutted cat, Apexi S-AFC, KYB AGX Struts, Eibach Prokits, Excel TZ-10 Rims

Hey,
I dunno about KYB AGX with Prokits, but Im running KYB AGX with H&R Sport. The sports are way too soft for the kyb and the ride is OK, but over bumps, it hits the bump stops cause the shock is longer than normal.

hmm I think you'll be fine, I got skunk2s though... I haven't had any problems.

http://www.hadesomega.info -car specz and movies 95 Eclipse RS | 76' 280Z | 89' MR2 | 99 Neon | 91 Zephyr
Who sez FF can't drift?

KYB's are good for a slight drop. if you plan on a mild drop than go with them. for anything more i'd suggest illuminas or konis

http://www.ocaddict.com

thanks beefgg for the sig

Thanks for the replies...I think I will give them a try...

Chad

MODS:
3" PVC CAI, GST Muffler, Greddy 4-1 Header, AFX UDP, 55 mm bored TB, P&P Intake Manifold, Corbin intake spacer, gutted cat, Apexi S-AFC, KYB AGX Struts, Eibach Prokits, Excel TZ-10 Rims

When you do the install,

MAKE SURE you cut the bumbstops in half.

This will give you extra travel and you will still have protection against bottoming out.

me with A-10's Avenger Cannon- can you say depleted uranium rounds?

www.blackjupiter.com (gaming computers - tell everyone you know!)
MODS:

Engine= 60mm TB, Greddy 4-1 Headers, AEM Short Ram, MSD Wires,