Hey guys. I am just about ready to start my rebuild. I have bought pretty much everything new. The only thing I didnt buy new were my rods/pistons(instead got a set of used from mitsu graveyard). I didnt b/c I dont have the money. My questions are: I should have asked before I did it, but I cleaned every single bolt that came out of my engine or goes into the block with my dremel using the wire brush. Is this ok to do? I hope so, it pretty much just removed all dirt and rust that was on there. my second question is I bought that chem dip stuff from autozone. It is the same chemical that is in carb cleaners to remove carbon deposits. Is it ok to soak my rods/pistons in there to remove all the carbon that was on them. Thanks in advance.

bump

For the rod bolts, I'd suggest just getting new ones... they are not that expensive. I believe I spent $4-5 on new ones from a dealership.

__________________________________
-Ryan