This is my new clutch setup for the aluminum rod 2.5L I have been working on. It is an unorthodox aluminum flywheel, VR6 pressure plate and a custom disk. The clutch facings are coated to raise the friction coefficent. This should be capable of holding 650ft/lb tq. best time so far 14.3 @ 101.1mph(no traction) www.cnnmotorsports.com
#88123, "RE: My NEW SBC setup." In response to Reply # 0
Yea, Baby!!! GRRRRRR....
SBC all the way.
USED TO HAVE...Everything you wish you had, and then some...
You are somebody special Tim, you matter! - from the admins (but nobody likes you, because your username is just like that other guy's, and you whine a lot)
#88125, "RE: My NEW SBC setup." In response to Reply # 2
Not to throw my own post off topic, but how is TQ freaks making out on the manifold? When I talked to them they said a few weeks yet. best time so far 14.3 @ 101.1mph(no traction) www.cnnmotorsports.com
#88126, "RE: My NEW SBC setup." In response to Reply # 3
Originally posted by extreme97nt Not to throw my own post off topic, but how is TQ freaks making out on the manifold? When I talked to them they said a few weeks yet. best time so far 14.3 @ 101.1mph(no traction) www.cnnmotorsports.com
Supposedly I'm getting pics from the fab guy tomorrow and I'll post them up. I doubt it though... He has my car at his own personal shop in WA.
How much did it cost for that clutch setup?
_____________________________________ Scott 90' GSX, 06' Effo SSL
#88133, "RE: My NEW SBC setup." In response to Reply # 6
Anyone Know what to torque the pressure plate bolts to? I pit some loctite on them and torqued them to 25 ft/lbs. They are kind of small and going into aluminum so I didn't want to over do it. best time so far 14.3 @ 101.1mph(no traction) www.cnnmotorsports.com
#88155, "RE: My NEW SBC setup." In response to Reply # 6
I does look similar ... but it's not. Look at the flywheel - huge differences. I can't tell from you pic RxR, but I don't believe there are starter teeth on the FW you're picturing.
#88177, "RE: My NEW SBC setup." In response to Reply # 9 Apr-12-05 05:55 PM by RxR_Eclipse
Ya the pic is not exactly what they sell, that unit comes all pre assembled like a CM, SPEC, LUK *sp* etc. That unit is off of ebay, clutch connection or some company etc etc and sells for 340+shipping. It is only rated for 60% more than stock holding figure your stocker is rated @ 140, so that one would be good to near 225 hp *weak IMO*. Although a CM is rated like 110% over stock which puts it somewhere in the 295 range. A much better unit. I emailed that company on ebay and have not gotten a response back from them on how much power their 'stg 4' will hold.
Search
Printer-friendly copy
1 User in Chat
That's the clutch I want to get too.. I can't wait to see your final setup! 
