|
Well as far as I can tell, for some reason, the ECU is pulling fuel like mad(-20+%) So either its dumping in so much fuel, the ECU is trying to pull it out,and running way to rich, OR, something is telling the ECU to pull fuel, when really the fuel mix is correct, and you are running too lean. I'm very suspect of the o2 sensor. MOstly because this is what is telling the ECU to do with fuel, in terms of fuel trim percentages. We have a 4 wire o2 sensor, which means its a heated sensor. Basically, there is a heating element in the sensor, to help it get up to its operating temps faster on warmup, so the ECU can go into closed loop to start controlling fuel quicker(mostly to cut down emmissions, and also,the 02 sensor doesn'tlike to work too well when its not up to temp). I guess I dont really know exactly what the ECU is looking at to tell it to go into closed loop..Don't know if it gets a signal from the o2 directly, or if it just see's coolant temp..Its not a cheap part to just "replace" to find a problem, but knowing if the heater circuit is bad in the o2,is very hard to find directly. Looks like most of your other datalog info looks good, so yeah its a little tough to figure out..the fact that it only does this for a few minutes, just makes me think that its an o2 sensor issue, and it runs fine when the o2 is warmed up enough to give its accurate info to the ECU...o2 sensors don't like to work too well until they are hot..  13.5 @108 MPH-2.2 60ft(stupid FWD!) S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential fuel injection) My webpage: http://eclipsed4evr.home.comcast.net -1998 Mitsubishi Eclipse RS-T- "Toy" -1992 Plymouth Laser Turbo AWD(SOLD) -2000 Honda CR-V(daily)
|