Welcome to the 2GNT Forum!
Home Site Background Info & Specs Mods & Tech Info CAPS Part Reviews Donate 2GNT Stickers
Search Printer-friendly copy 0 Users in Chat
Top 2GNT Technical Performance/Engine topic #69522
View in linear mode

Subject: "CEL 25" Previous topic | Next topic
fungulFeb-27-04 09:37 PM
Old School 2GNTer
163 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#69522, "CEL 25"


          

Has anyone had this? The PCM code list says its the idle air control motor but I can't find it in the chiltons under that name. The only thing it has listed is the IAC which I guess stands for idle air controller and it is located underneath the TPS on the throttle body. Is this IAC the same thing as a idle air control motor? Has anyone had this problem and if so what were you symtoms?

Thanks,

Dean.

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Replies to this topic

djtrickeeFeb-28-04 05:05 AM
Donating 2GNT member
5924 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#69538, "RE: CEL 25"
In response to Reply # 0




          

yes you are correct. it is on the backside of the throttle body. The lower one. The top one is the TPS- Throttle Position Sensor. If you are getting a code for the IAC there are a bunch of threads on here about how to clean it, how to fix it and how to test it.

.........................................................................................................................

Built. That's All...
.........................................................................................................................
www.monkeybuttpirate.com
.........................................................................................................................
2 Fingers of Scotch with a milk back... Stat!

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

    
fungulFeb-29-04 04:07 PM
Old School 2GNTer
163 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#69672, "RE: CEL 25"
In response to Reply # 1


          

ok I did I search and found how to test it. I checked the ohms and they are just fine. I pushed in the plunger but I am having alot of trouble pulling it out (havent tried pliers yet). Is it always hard to push in and out? Also while I was in there I checked some other stuff and found that the ignition coil is bad. Would a bad ignition coil cause a cel 25 since it would make it hard for the car to keep idle?

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Top 2GNT Technical Performance/Engine topic #69522 Previous topic | Next topic
Powered by DCForum+ Version 2.2
Copyright 1997-2005 DCScripts.com, Copyright 2005-2026 2gnt.com
Generated in 0.065 seconds, executing 18 queries.