Welcome to the 2GNT Forum!
Home Site Background Info & Specs Mods & Tech Info CAPS Part Reviews Donate 2GNT Stickers
Search Printer-friendly copy 0 Users in Chat
Top 2GNT Technical Performance/Engine topic #56553
View in linear mode

Subject: "Break in procedure??" Previous topic | Next topic
pea_jayAug-03-03 08:14 PM
Member since Jun 01st 2003
415 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#56553, "Break in procedure??"


          

Well i just did a search and most of the break in questions were for the turbo engines. I spun a bearing and had to replace a bunch of parts, and i also went ahead and got new rings. I think the break in is like dont take it over half throttle, and vary your speeds? I need some more info on that. Also, I am supposed to change the oil after 500 miles because of the machine shop may not have gotten all of the metal shavings out of the crank? Then at 1500k then 3k after that? I need some info before i blow my motor or something. Thanks in advance

96 Eclipse Base 5 spd
Rebuilt engine w/ forged internals, APC Air Filter, Clear bumper lenses, 15" ICW wheels, Alpine v12 amp, 2 12" Xplodes, 5.6" lcd monitor, Dvd player, Playstation 2, Power1 Exhaust, Aerospeed Wing, Altezza tails w/ painted center, 20% tint, Silver Graphics, Audiovox alarm system.

Big transformation underway this winter!

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Replies to this topic

TeamDR1665Aug-04-03 06:15 AM
Donating 2GNT member
14692 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#56561, "RE: Break in procedure??"
In response to Reply # 0


          

There's many different ideas on how to break in. This is always a touchy subject. Some people say drive the shit out of it, others say to take it easy, the miles and days between oil changes are al different, but it seems like the one thing everyone agrees on is make sure the engine is warmed up before you go getting on it.

I took the following approach:

Stay under 5 grand for a couple weeks, but make sure to vary the RPM. After a couple days, I would make it a point to wind her up to 4k at the shifts and maybe take her to 4500 a couple times. Be sure to wind her up and then stay in that gear and let her compression brake back down. You want to load the rings both under accel and decel. A couple times, I went to an industrial park where there was no traffic and left her in 2nd to wind it up to 4500 and then coast back to about 2000 a few times.

I changed my oil after the first week. Then I'm waiting 2 weeks (okay, so I missed the two week mark, but I'm doing it next weekend, so emoji ). Then I will go a month, then 3000mi, then I'm going to the Mobil 1 synthetic. Make sure to just use the cheapy conventional oil. No synthetic for a few thousand miles.

Just keep your radio off for a while and keep an ear out for odd sounds and keep your eyes peeled for smoke or leaks and vary the rpm and you should be fine.

Congratulations on the birth of a new engine! emoji

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Top 2GNT Technical Performance/Engine topic #56553 Previous topic | Next topic
Powered by DCForum+ Version 2.2
Copyright 1997-2005 DCScripts.com, Copyright 2005-2026 2gnt.com
Generated in 0.064 seconds, executing 16 queries.