Today when i pulled out my cylinder #1 Spark Plug Cable..the tube was drenched with oil. Eveything was soaked....so i went to check the oil level and sure enough it was low. I tried to clean the tube as much as possible..spark plug seemed to be ok..but i cant trace where the oil is seeping in. I checked cylinder #2 and it was slightly oiled and #3 and #4 where OK. *The car is running fine and it doesnt blow any smoke...so I dont think its the HG or piston rings...but i'll do a compression check. Could it be the valve seals? I just noticed this when i changed my batt. & I decided to replace the plugs as well. Can anyone help me out and show me how I can fix this? Thanks in Advanced.

ROB

95 Eclipse GS || Custom 9.6:1 JE Pistons || Eagle H-Beam Rods || MLS Headgasket || SBI Lifters || SBI adjusters || Fidanza Cam Gears || AFX Underdrive Pulley || Melling Oil Pump || 97 Front end Conversion || GTR Wing || MSD Ignition || Accel wires|| AEM Cold Air Intake || P&P intake manifold ||P&P Intake Ports || Jeep TB Mod || EGR Block off plates || NGK Plugs || Front/Rear/Lower Strut bars || VIS coilovers || Clear corners ||custom headliner || in dash LCD screen || PS2 || Eclipse CD player|| 18" Racing Hart C4 || B&M Transcooler || Final Drive Gears || Shift Kit || Energy Suspension Motor Mounts || Torque Converter Kill Switch || Solid front mount ||

You just need to replace your spark plug O-ring gaskets and your valve cover gasket. A simple $30 or less fix and it shouldn't take you more than 2 hours to fix.
MiztahfooLish...'95 RS & '03 Altima 3.5 SE V6 5spd

CAIw/K&N/OBXexhuast/shortshifter/Accel8.5mmwires/Blitzrear/99conversion/diamondplatemats/Powerslotrotors/M3LEDmirrors/57mmTB&manifold&More

>You just need to replace your spark plug O-ring gaskets and
>your valve cover gasket. A simple $30 or less fix and it
>shouldn't take you more than 2 hours to fix.

Yep, and that 2 hours is if you have problems. Very eas

Allan
2008 Magnetic Black 350z NISMO /1976 Austin Mini 1098 Special (export)

Member# 1980

Here's a step by step:

http://www.2gnt.com/www/corbin/vc.html

Corbin

'95 ESI-T
HRC+FMIC+ETC...



Gimme fuel...Gimme fire...Gimme that which I desire

2 hours? My God, I over-estimate time... but I think, a one armed man, with no thumb could do it faster.



15.9 @ 86.7mph

Smooth idle? We don't need no stinking smooth idle.

Mods List:
http://highlander.dsmpower.com/sig.htm

check for cracks in your valve cover where the spark plugs go. I have the same problem and replaced the gaskets and its still leaking. I found very small cracks in the hole that allows oil into the spark plug tube very slowly. For the time being i just clean out the tube every time i change my oil until i get a chance to look for a new valve cover. There usually no more than about half an inch of oil in the bottom so i just clean it out. Never heard of changing the spark plug oil huh...

_______________________________________
The end of the internet begins here... www.broke-off.com