I got the harmonic balancer pulley removal tool(kit) from Autozone. So my question is, there are black bolts that came with the kit, they don't fit exactly into the pulley. So what kind of bolts did you use for removing it. Any info would help, thanks.

Boca Raton, Florida
95 Eclipse GS- sold
99 Eclipse GSX- 386awhp
98 Eclipse GS- sold
92 Prelude

i'm pretty sure it uses some type of 3/8" bolt. don't think it's metric. not sure about the thread pitch though.

2016 WRX STi Limited (current)
2001 A4 1.8tqms (donated)
1991 GVR4 #1933 (sold)
old.dsmregistry.com/detail.php?carid=218 (dismantled)

anyone else? i need some help with this

Boca Raton, Florida
95 Eclipse GS- sold
99 Eclipse GSX- 386awhp
98 Eclipse GS- sold
92 Prelude

Slightly old thread, but the AFX pulley does indeed take standard 3/8" bolts, found at any hardware store or Home Depot, ect.. Get 3 bolts that are about 4" long. Shorter bolts may not work, as there is not enough room to get from the pulley to the puller with too short of a bolt. Also, pick up 6 flat washers, and use 2 on each bolt on the back of the puller, right behind the bolt's head, to help distribute the forces and from keeping the bolt head square against the puller. Hopefuly this will help clear up the questions.

13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)
My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)