Hooked up my scan tool and it told my the map sensor voltage was high. I installed the star performance turbo kit and the map sensor By-pass. Is this normal, or is the map sensor by pass bad. Thanx

Your Garage is not worthy
For the Masterpiece you built
That only looks like it cost a Fortune
While most flaunt their cars by going fast
You show off Standing Still

i not for sure cause i don't have a turbo on my clipse but i think you need to get a 2-bar or 3-bar map sensor depending on your boost.

dsm/mitsubishi service manuals https://www.mediafire.com/folder/5k14qlaulb9s1/dsm_mitsubishi

service manuals(my whole collection) https://www.mediafire.com/folder/ac51jwwa3g1n1/automotive_manuals

no, your bypass is not working correctly,either try hooking it up again correctly or you should get the missing link from http://www.synapseengineering.com/html/ml003.html
its much better than any black box clamping diode, its a check valve its great

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

Do you have this missing link on your turbo eclipse? Any other place that sells it cheaper and it says that its made for a acura honda. Will it work on a eclipse. Thanx

Your Garage is not worthy
For the Masterpiece you built
That only looks like it cost a Fortune
While most flaunt their cars by going fast
You show off Standing Still

Make sure and buy the ML003. That's the one for the non turbo eclipse. Many of us use it. The "fuel mappers" and even the "voltage clamps" from Split Sec are known to fail.

They cost around $50 from Group5 Motorsports. http://www.group5motorsport.com/cgi-bin/GRPstore.cgi?user_action=detail&catalogno=SE-MissingLink

_____________________________________
Jason ESi-T

04' BMW 325Ci
91' Nissan 240SX
98' Eagle Talon ESi (sold)