On the way home from work ttonight my tranny let go! I was at about 45-50 mph in 2nd and shifted quickly into 3rd. After that it jus made noise. A horrible grinding noise and I didn't go any where. The car just revved. So i pulled to the roadside and tried to get it to go again. Nothing. All it did was make the same horrible noise when I was going down the road. The noise was les prominent when th car was idleing and out of gear but was pretty audible when I put it back in gear. When in gear it just revs and does nothing.

There were no symptoms prior to the incident. Any thoughts?

Built 420a
NER turbo kit T3/T04s ball bearing
AFX UDP
Crane 0014 cams

Do you have other gears w/o noise?

Shit is all apart. Typical...

It makes noise in all the gears. Doesn't move in any gears, even reverse. Just grinds in all gears, especialy when the clutch pedal is released.

Built 420a
NER turbo kit T3/T04s ball bearing
AFX UDP
Crane 0014 cams

Sounds like a dead clutch to me.

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

I know that in another thread, they were talking about the symptoms of throwing your diff pin. sounds kinda similar.

peace
WIKKI


THAT is not f**king THAT!
THIS is f**king THIS!

if u have a hole or left fluid on the ropad where it made the noise your diff pin came out if not then probably clutch..

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

Just out of curiousity, if the pin does come out, is it as easy as putting a new pin in, or is there more work involved. Just got a call from my mechanic after swapping to a new block. He says the job is complete except for a noise that seems to be coming from the tranny. I hate when more crap goes wrong... Sorry to steal your threa

if the pin comes out it will knoc a hole in the tranny casing which ruins it most likly....

You can have it cheap, fast or good. Pick any two.

If you want it cheap and fast, it's not going to be good.
If you want it cheap and good, it's not going to be fast.
If you want it good and fast, it's not going to be cheap.

>Sounds like a dead clutch to me.


That's wha I ws thinking too!. I might tear it down tomorrow at the shop. The anticipation is killing me.

Built 420a
NER turbo kit T3/T04s ball bearing
AFX UDP
Crane 0014 cams