So my clutch started enganging about an inch away from the floor. I check the resivior and empty - i fill, bleed and I get no resistance. I look under the car and no leaks then look up near the clutch and there - a leak. The boot that covers the shaft is leaking from there. I did a search and found that people use the rebuild kit which is what I'm gonna buy. How hard or easy is it to take off the master cylinder and replace it? Thanks

Alvin

96 RST

Star Stage I turbo kit /Starion I/C w/ 2" chrome piping / GReddy Type-S BOV / Missing Link / Custom APEXi- GReddy 2.5" exhaust / 55mm ARD TB/ Nology wires / APEXi EL mech boost gauge / Autometer A/F gauge / Southland Dual Friction clutch / B&M short shifter / Energy Suspension shifter bushings / 16" GSX Rims / Front/ Rear camberkits / Eibach Prokits / Tokico Blues/ Front Upper, Rear Lower strut bars / Rear GST sway bar/ GSX Dual Piston Calipers, X-drilled/ slotted rotors

Alvin

http://www.cardomain.com/id/96rst

its not all that hard.. u have to take out a buncha things to get to it tho..

its tough to get tot he bolts that are holdin it in place, and the cotter pin that is chillen is a pain in the ass too...

the chiltons has several decent pix, and the FSMs helpd too...

good luck, id say, rip her apart one day, get the master cylinder, replace whats needed over night, and put back together in the mornin...

feel free to email me at seangordon@hotmail.com if you have any specific ?s..

payce

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki

That's all well and good, but it sounds like a slave cylinder. The master cylinder is bolted to the clutch pedal, and the slave cylinder is bolted to the transmission. I only think this because I don't remember the master cylinder having a rubber boot...
-=B-=

Dude, Boeing called. They want their wing back.

Dark0ne95: There is a butthole on that girl that his going to feel the wrath of 23 yeras of worldwide hate.
Me: Can I put that in my sig?
Dark0ne95: GO right fucking ahead.

Okay I took the master cylinder out, broke it down and sprayed it with brake cleaner. There were no visible leaks or cracks so I put it back together and it worked. No leaks so far
Alvin

96 RST

Star Stage I turbo kit /Starion I/C w/ 2" chrome piping / GReddy Type-S BOV / Missing Link / Custom APEXi- GReddy 2.5" exhaust / 55mm ARD TB/ Nology wires / APEXi EL mech boost gauge / Autometer A/F gauge / Southland Dual Friction clutch / B&M short shifter / Energy Suspension shifter bushings / 16" GSX Rims / Front/ Rear camberkits / Eibach Prokits / Tokico Blues/ Front Upper, Rear Lower strut bars / Rear GST sway bar/ GSX Dual Piston Calipers, X-drilled/ slotted rotors

Alvin

http://www.cardomain.com/id/96rst

nice.... the rebuild kit for the clutch master cylinder is only 15 bux at napa.........

good to hear its fixd

03 srt-4 13.130@112.47mph (n2o, stock turbo, 10/2003)
now: 20g, portfueler, bpu+++ (track/dyno times tbd...)

i farted on your wiki