Ok I just got my drivers side axle replaced but now anytime I accelerate my car pulls to the left. any ideas. TIA

95 eclipse RS

14.80 @ 94mph with no turbo

Obviously,
after any repair like that you need an alignment

1998 dodge avenger 4 cyl AT
Mods are:
Not enough

Thats what i thought but the shop told me that I didnt becuase all they had to do was knock the lower ball joint loose and it shoulnt affect the allignment. I was going to get that done tomorrow but I just wanted some input.

95 eclipse RS

14.80 @ 94mph with no turbo

i have removed my tranny many times and never got an alignment after it... but i'd recommend it... same with axle replacement... i dont drive my car enough to really care right now though.

-matt

97 Eclipse GS-T with 6-bolt engine

hey i need help asap, let me know how you got the short drivers side axle out, from the tranny.

i have an rs also, please lmk soon, im working on the car as we speak, i've seen other threads and pics, but we don't have that little crack to put a pry bar between to pry it out right? caused i looked on my rs, it's just the axle going into the tranny and you can move it like 1mm left to right...

but how did you takes yours off? if you can call me at 707-815-5612 i need to get this done asap, thanks man
-daniel

All you do is put the prybar in between the tranny case and the axel and pry it out. If you notice there is a skinny shaft that acctually goes into the tranny and there is a much larger piece that is more the size of your fist. You pry between the tranny case and that piece that is as large as your fist. It's the only gap that is there. Here is a mock up in paint


Also see this post from dino explaining exactly how to do it...
http://forums.2gnt.com/dcboard.php?az=show_topic&forum=6&topic_id=21148&mesg_id=21148&page=

I edited to the wiki!

Don't pry, get a long flat head screwdriver (or something similar) place it on ridge on green thing and hit it with a hammer (screwdriver) axles like to be *POPPED* out, not pryed.

__________________________________
-Ryan

use a pry bar to pop them out just get it a couple good knocks and then it will pop.

guys see what kirby made with paint, i don't have that gap clearance to actually pry it out or pop it?

there is no space it's just a solid peice to the tranny, no gap or anything to pry or pop?

lmk thanks

axles shouldn't really be pried out, they should be popped. here is how i did mine. the picture is for the passanger side axle, the procedure works the same for the driver's side.

2016 WRX STi Limited (current)
2001 A4 1.8tqms (donated)
1991 GVR4 #1933 (sold)
old.dsmregistry.com/detail.php?carid=218 (dismantled)

nate im turning you in to the emissions board!!! wheres ur cat?!!!! oh yeah cats are for pussies