|
i just got my engine rebuilt and put back in the car. i got all the sensors connected, all grounds in place and when i go to start it it cranks bt won't start. i scanned the the ecu no codes thrown, also ran a test on all the sensors and it came back that they are all fine. but i don't get any power to the ignition coil.
i hooked up a a'pexi s-afc and a avc-r before i stated it up to, would this have fried anything in the ecu to make it not start? or could there just be a bad part in the ecu? the scan said that the cu was fine. one of my friends thinks that the when i hooked them up it ight have shorted out the ecu. has anyone ever had this problem or know what i might be over looking? i have went over all the sensor connections a dozen times and they arein the right place and clipped in tight.
if anyone can help i would greatly appreciate any thouhts or ideas.
98 RS, Star Stage 2 with E trim, JE 8.6:1 pistons, total seal rings, bored .020, clevite 77 main and rod bearings, polished and knife edged crank, mellings oil pump, crane valve springs, titanium retainers, pt lifters, pt rockers, crane cams #014,fidanza
|