Hey, what's the easiest way to get the block out?

- Unbolt the tranny? (I'm A/T) or pull everything out together?

- Remove the head and pulleys first or just leave it all on?

- Can you really jack on the oil pan?? (To remove motor mounts)

For some reason, Chiltons skips from timing belt steps to "we will assume your block is now on the workbench."

TIA, I've never done this before.

>Hey, what's the easiest way to get the block out?
>
>- Unbolt the tranny? (I'm A/T) or pull everything out
>together?
>
>- Remove the head and pulleys first or just leave it all on?
>
>- Can you really jack on the oil pan?? (To remove motor
>mounts)


Pull the front suspension. Remove the axles. Remove the center member (under the car, attached to the front motor mount). Remove the washer bottle, battery, battery tray, battery tray mount bracket, intake pipe, radiator, both upper and lower hoses, and both heater hoses. Disconnect fuel feed line, air temp sensor, brake assist line, MAP sensor, TPS and idle air harnesses, and the injector harness. Disconnect the stock fuel pressure sending unit and knock sensor. Disconnect the vehicle speed sensor from the back of the tranny, as well as the rverse light sensor and any other harness you have on the at i don't on my mt. Remove PS pump bracket, throw PS pump off to the side, unbolt AC compressor bracket, throw off to the side.

Grab the engive with an engine hoist to hold it steady. Pull both side motor mounts, lifting and lowering with the hoist when necessary. Remove rear mount(under washer fuild res. location). Hole the engine level with the hoist. Lift out.. watch for any harnesses that may still be connected.

I may have missed a few things. That's about all of it, though.

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

hey dan, follow dinos directions, you should be done within 10 mins hehe... i wish it was as easy as it was explained... let us know dan, i want to help you out gives me some more knowledge and experience...hehe hey dino, want to come to so cal and do my engine rebuild? hehe


Michael 99gs
Boost It!
Mods:
no time to put in yet:315cc injectors.
Hrc Stage 2
S-FMU
Crane HI-6DI2
Greddy Type S Bov
VC-2
Road Race Catch Can
Greddy Profec B & Switch
Apexi WS Catback
Super Afc
Autometer Boost,
Egt,Tranny Temp Gauge & Cooler
Air/Fuel Light & Digital
Tokico Adjust Struts
Eibach Pro Kit Springs
Front & Rear Upper Bar
CarCraft Interior
Sound System= Bring it On

Michael
99gs hrc stage 5000 SOLD...
2004 Honda Accord V6 (240 hp)stock
what other car should i buy?? hmmm
Car info & pictures at http://www.cardomain.com/memberpage/520269

I might be pulling it this weekend, you free? Kaiser, how bout you? I'll wait if you're busy, I've gotta go junkyard shopping for a bunch of stuff eventually. I printed out "Darkone's Bible" for our use.

Darkone- You rule. So... just leave the tranny bolted on until I get it out of the car?

(BTW, I just spent the morning reading the Turbo forum from the beginning, so I have a much better perspective on things now ) Want a summary?: Oil sprayed all over your engine means you broke your pistons.

>"Darkone's Bible"

>Darkone- You rule. So... just leave the tranny bolted on
>until I get it out of the car?

Yeah. it's the easiest way ..

It's not as easy as i made it sound, but that's just about everything you're going to have to do in a scrotum (nutshell).

Just don't break anything

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/

Someones going to have a headache, have someone overlook what your doing if at all possable, and you are about to learn more about your car and most importantly yourself than 1 might think possable.. goodluck.

i might be free sunday for a bit... if you could wait till next weekened i will have more time to give you a helping hand if i can since i dont work... this sunday i can only stay for a bit if so i have alot of projects due for school i got to finish =(

Michael 99gs
Boost It!
Mods:
no time to put in yet:315cc injectors.
Hrc Stage 2
S-FMU
Crane HI-6DI2
Greddy Type S Bov
VC-2
Road Race Catch Can
Greddy Profec B & Switch
Apexi WS Catback
Super Afc
Autometer Boost,
Egt,Tranny Temp Gauge & Cooler
Air/Fuel Light & Digital
Tokico Adjust Struts
Eibach Pro Kit Springs
Front & Rear Upper Bar
CarCraft Interior
Sound System= Bring it On

Michael
99gs hrc stage 5000 SOLD...
2004 Honda Accord V6 (240 hp)stock
what other car should i buy?? hmmm
Car info & pictures at http://www.cardomain.com/memberpage/520269

damn baby, you know I'm always down with breaking other's people's shit....hahahaha. .Print off Dino's bible and we should be alright. If we have any problem, we can always try calling James or Dino for help .

I'll ask my GF to see if she wants to lend a hand this weekend.
More than likely it will be a whole weekend project.

can't we just leave the block in there? and rebuild it like what james did? or are you doing that 2.4L thing?

Do you have a second car handy Dan? Engine Hoist?

I responded to your mail. I'm down this saturday morning if you like.

lates.

-K-

Just wanted to let you know that I did not have to remove my tranny to pull my motor, even though it was a M/T. The ONLY problem I had was the little plate that's on the bottom of the bell housing portion of the tranny. It did make it a little more difficult to get in that way, but damn, didn't have to pull the wheels off even, let alone pull apart any suspension or spill a drop of tranny fluid. I do not know if that method works with the A/T though.

I even left the alternator on when I pulled mine. No difficulty besides that one little plate.


Clint
97 Eclipse GS

Kaiser - I was gonna rent an engine hoist... I have access to a pickup and a beater on the weekends. Let's at least rip it out saturday. I'll make sure I give better warning so Pn0y can come for the install in a couple weeks.

I'm going to try really hard to get a 2.4, but for now, I'm sure I've gotta pull my block. It's definitely going to need some machining. I drove almost 4k miles on a cracked piston.