Anyone milled there head? Any ideas exactley how much compression is raised by shaving it like 30 over? Does Howell or anyone carry a THICK head gasket for this process.

Hand made NOT mama paid!!

You want to mill the head, and then add a thicker head gasket? Are you trying to increase or reduce compression? Milling will increase, using a thicker head gasket will reduce.



Eric Madden

want to raise didint know if the gasket was needed to be thicker

Hand made NOT mama paid!!

Do a search through the forums we've discussed this is some detail. But you definately do NOT want a thicker gasket. Milling a head will increase compression. .030" would be roughly .7:1 compression ratio raise (This is a rough estimate done in my head quickly so it's not an exact number.) BUt a thicker head gasket would negate the effects of milling.

"The world is a dangerous place to live; not because of the people who are evil, but because of the people who don't do anything about it." - Albert Einstein



Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/

Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, Crane Fireball HI-6DI2, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors & Carbon Fiber Pads

To Be Installed: Ported/Polished Intake Manifold 1/2, Rear disc brake conversion kit w/, Rear KVR Cross Drilled Rotors & Carbon Fiber Kevlar Pads, SS Brake Lines

Firefly:
Mal: You don't know me, son, so let me put this to you plainly: If I ever kill you, you'll be awake. You'll be facing me. And you'll be armed.