What year or years Neon's has our tranny in it???

Is it going to be the exact same thing or is there differences that I will have to fix to get it to fit?


TIA
Brian

I think one of the gear ratios are different. Also, the bellhousing needs to be swapped to ours to make it fit.

Kris
"Someday............I'll have traction problems!!!!"
Tampa, FL
Pinoy Turbo 2GNT

1999 HRC Turbo RS
Stage 2
Auto with BOOST!!!!!!!!!!!!

what ^^^ said. but the gear ratio usually is different by sohc and dohc. check out neons.org for exact info.

http://home.bendcable.com/optimuspeterson <<<<HRC Stage 2 and Star Instructions
95 Eclipse - SOLD | 93 BMW 318is - SOLD | 2000 S-10 Extreme on 20's - SOLD
93 Toyota/shaved/bagged/body dropped - SOLD | 97 GSX - SOLD
2006 Scion tC

Let us know when you find out for sure which one it is.

"Natty Ride"


http://dirty.thisfreedumb.com/

OKAY THIS IS THE LAST TIME I POST THIS LINK, I JUST POSTED THIS LINK NOT EVEN A WEEK AGO.

EVERYONE READ THIS AND SAVE THE LINK!!!!!!!!!!!!!

http://sun.science.wayne.edu/~jwaleke/trans/


________________________________________________________________________________________
current status - unknown
Project: Baby on the way


http://hometown.aol.com/ohshootuhh/
www.Fast420A.com

Flame Red SRT-4 GT40,8.5:1 Built Shortblock, Brian Crower Stage 2 Cams, etc etc etc...

Ok saved.

Thanks

Can someone post the link to the transmission cross reference? I can't find it.

>Can someone post the link to the transmission cross
>reference? I can't find it.

BWAHAHAHAHA!!!! Seriously though... let's make sure i understand this. Say i have two cars, identical in every way EXCEPT for the final drive ratio. one with 3.55 and one with 3.94. Which one would have a theoretical higher top speed?
EDFDC OWNZ

Will Werk for Mods

1995 RS

Current Mods:
Cracked Front Bumper
K&N Intake
Flowmaster Muffler
Platinum +4 Plugs
MSD SuperConductor Wires
and one heavy Right Foot!!!!

**Badgers??? We don't need no stinkin' badgers!!!**

**No Shirt, No Shoes, No Dice!**

**************
Fucking Kangaroos.
**************

Ok I picked up a '99 SOHC neon tranny w/ only 20k on it for 400.00. I didn't want to buy one but it seemed to be the cheapest and easiest fix for my problem. (I hope)

As stated in the above replies the bell housing is a little different and can't be used. Aside from that everything is basically the same. It was cheaper to go get a neon tranny and swap the bell housing than to just go get on of a 2gnt-saved about 300.00. The cheapest price at the junk yards for a 2gnt was like 700.00 vs 395.00 for the neons. Whod a thunk it...

The higher the ratio number the less top end you'll have, and run higher rpms at all speeds. If your looking for higher speeds and not running crazy rpms at highway speeds go for the lowest ratio #.

ASE certified master auto technician

Hey Justone, Make sure the shifter pieces are the same as your Eclipse tranny. You may need to cut off a counter weight on it so the motor mount will go on. I had to with mine.


________________________________________________________________________________________
current status - unknown
Project: Baby on the way


http://hometown.aol.com/ohshootuhh/
www.Fast420A.com

Flame Red SRT-4 GT40,8.5:1 Built Shortblock, Brian Crower Stage 2 Cams, etc etc etc...

That was the first thing I did when I got it home.

Does anyone have a good method or tool they use to get bearings off?

I got my Neon tranny that I used for my 99 RS for $200.......

If anyone is in PA or near it I can get a bunch more neon trannys for $200 a piece........

As the other guys have said...
The bellhousing is different.......
Counter weight will prob need cut off...

Other than that its the same thang.... NVT-350 core.... used on quite a few diff cars........

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~

Megasquirt powered 420A
Custom turbo system

http://www.ms-custom.com