ok so im doing the atx to mtx swap, and i know youre supposed
to replace the computer w/ the one for the mtx, but im
wondering about the speed sensor in the back of the tranny, is
it easier to just replace the harness w/ the one from the
factory mtx equipped car, and if so, how hard is it to remove
the harness... or B, do i just splice the wires..and if so,
does anybody have a schematic to do so, or know where i can
get one? im pretty sure theres a post up about this somewhere,
but i couldnt seem to find it using the search...

Lots of posts in this section, even more in the ATX section. Ill Draw something really crude for ya.

your easiest bet is to splice. no need to change the whole harness for 3 wires.

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

aight ill see what i can dig up...and why is it that youre like the only guy who ever responds to the crap i post? lol thanks for the help

I know what its like to need help. Althoug all of this Has been put up before and answered.
Here is the Reverse Switch
http://www34.brinkster.com/chamukogs/ATtoMT%20with%20pictures%20in%20document_files/reverse.bmp
And the Speedo
http://www34.brinkster.com/chamukogs/ATtoMT%20with%20pictures%20in%20document_files/vss.bmp

Wouldnt hurt to get some points

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

lol ok you got it...besides i owe you a few points anyway from previous posts... oh, btw, those links wouldnt load w/ the pics in em...but i did find your write up...if i remember ill snap some pics of mine while im at it and maybe you can use a few

sometimes you have to refresh or cut and paste the addy, dunno why

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

ok so for the VSS, you splice the yel/wht wire to the 3rd terminal, the blk/grn wire to the second, and the yel. to the 1st terminal right? how about the reverse lights? too small for me to see.. lol and are the terminals for the VSS determined w/ the connector clip facing up or down?

look at the VSS It should have a bigger space between 3 and 2.

As for the reverse, its just a switch. Its either open or close, so even if you wire it backwards it will work.

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

ok. thanks for having some patience with me on this.

no prob. I really want all of you that are attempting this to take pics, notes and make suggestions. I really want to get the swap info and write up re writen and as easy to understand as possible.

Member # 751


FOUNDER of the Central Cali chapter of 2GNT!
(I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for

well ive allready gone through the process of removing the tranny(and engine...so much easier...) but when im going back in with it, ill try to take some pictures and maybe we can coordinate a write up or something and get it on the main page.