I searched and actually didn't find much, odd. Anyways, I have always been extreamly paranoid about my car and was looking into some more saftey features. Since I plan on doing some drag runs and get into autox I figure a transmission cooler could only help. I have a few very stupid questions about them however. I have only seen them used in automatics, but it wouldn't be a bad idea to use one on a manual correct. I know it may be overkill but it does stay over 90 and into 100 a lot where I live and the car is stored in the winter so I think its a good idea. I like the B&M supercooler series but it says its an automatic transmission cooler, but it shouldn't matter right? The 70255 is 11in x 5.75in x .75 in which seems enough to me, assuming it will fit in front of the radiator. Now for install, I found this picture
Seems pretty easy, there is a tube comming from the transmission to the stock radiator, then one leaving the stock radiator back to the tranny? Anyone know which one is which?
Last, Is there anything else I should know about these? Just mount it in front of the radiator on the drivers side? Is it actually worth $50?
Well, sorry for all the stupid questions but hey, everyone has to learn sometime right?
#5469, "RE: Manual transmission cooler?" In response to Reply # 0
Eh, I really can't find anything about a manual transmission cooler, hopefully they can actually be used otherwise I will feel pretty stupid. Someone prove me wrong.
#5474, "RE: Manual transmission cooler?" In response to Reply # 1
ok dude, just some questions and food for tought.
1.) How will you be Pumping the oil? 2.) Why do you think that the oil in there ( aluminum case) would get hot enough to cause problems? You forget that the oem manufacturers test cars in extreme heat and cold...just for that reason. 3.) Where wouls the oil come in and out of? 4.) only ATX radiators have the built in coolers.
I would not worry about it man, Guys that beat, abuse and push 4 times the power this tranny was designed for are not having problems...why would you? Just maintain it and it will do its job and more.
Member # 751
FOUNDER of the Central Cali chapter of 2GNT! (I got kicked out after I refused to go Cow tiping) - Hehehe you know who this is for
#5478, "RE: Manual transmission cooler?" In response to Reply # 3
99.9% of all manual transmissions won't need a cooling solution. Automatics work fundamentally different and have lower efficiency, which means that wasted energy gets turned into heat which needs to be transferred somewhere, in most cases to the atmosphere through a radiator.
#5479, "RE: Manual transmission cooler?" In response to Reply # 4
Thanks guys, no need to bash me though as I was just wondering. I know very little how transmissions work and their cooling systems. I also clearly stated that I didn't know if it was needed or possible. I asked to learn, which I did. Thank you for the explinations.
#5480, "RE: Manual transmission cooler?" In response to Reply # 5
I considered something like this a long time ago, but realiztically, you'll never have enough waste heat in the trans fluid to need it. As well, you're just adding complexity with a pump to move the fluid ($$$) plus lines to the cooler.. in truth, your transaxle would be best served with a pump-fed filter over a cooler, but even that is a bit overkill. Use a bigger trash magnet and change your fluid every every ten thousand miles and its a non-issue.
______________________________ If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.
'95 Eclipse TurboGS (garage deco) '95 TSi AWD (restoring a survivor) '97 Talon ESi-T (poor impulse control) '99 Eclipse RS-T (daily beater) '13 Evo X (mostly stock) '17 Sienna (Middle Aged Dad Mobile)