ok i have a serious problem. I have a spec stage 3 clutch that has maybe 1500 miles on it and i have done the clutch line mod with the stainless clutch line, now i have no clutch. would being low on fluid in the tranny cause it b/c i noticed my drivers side axle is leaking a little. i have checked the clutch fluid and it is full and clean. i was just wondering what it could be

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on

check your brake master cyl. see if there is any fluid in there. try bleeding your clutch. look at the rubber boot by your slave cyl and see if it is leaking. does it just not disengage or what?

Having Problems? Heres my Three step solution to anything 2gnt related.
Step 1: Put down everything in your hands.
Step 2: Grab a lucky strike, Smoke it.
Step 3: Walk to the fridge, double fist some keystone ice, sit down in the shade, drink one beer, finish cigarette, drink other beer, roll a joint, smoke it, walk back to your problem, and in about 5 minutes the solution will come to you.
If not. Go here: here

If still nothing, your trying to hard. Start over at step 1.

it doesnt disengage at all even with the petal to the floor.

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on

SOunds like you still need to bleed it. Installing a stainless clutch line introduces a lot of air...

_________________________________________
I'm the guy that bans you for breaking the rules. I am the troll killer. I am the law here.

i flushed the system out and i have a strong petal. the clutch just isnt fully disengaging and i checked the master and slave cylinder and they arent leaking and the resivor is full

Mods: JE8:8:1 pistons,Eagle Rods,fully built head w/1mm Rev valves,crane titanium springs and retainers,ported and polished head and intake mani,Hrc2 turbo kit,sfmu,safc,turbo xs dual stage boost controller,turbosmart megasonic,Fluidyne radiator,160deg thermo,spec stage 3 clutch,aem front and rear big rotors,3" hahn dp 3" back exhaust,stage 2 axles,and the list goes on