| Go back to previous topic |
| Forum name | Manual Trans - NV-T350 |
| Topic subject | NEED HELP ASAP!!!! |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i34&topic_id=3024 |
3024, NEED HELP ASAP!!!!
Posted by Sitinlo, Jun-20-04 06:52 AM
ok i have a serious problem. I have a spec stage 3 clutch that has maybe 1500 miles on it and i have done the clutch line mod with the stainless clutch line, now i have no clutch. would being low on fluid in the tranny cause it b/c i noticed my drivers side axle is leaking a little. i have checked the clutch fluid and it is full and clean. i was just wondering what it could be
|
3027, RE: NEED HELP ASAP!!!!
Posted by 420AYE, Jun-20-04 09:20 PM
check your brake master cyl. see if there is any fluid in there. try bleeding your clutch. look at the rubber boot by your slave cyl and see if it is leaking. does it just not disengage or what?
|
3030, RE: NEED HELP ASAP!!!!
Posted by Sitinlo, Jun-21-04 02:20 AM
it doesnt disengage at all even with the petal to the floor.
|
3032, RE: NEED HELP ASAP!!!!
Posted by admin2, Jun-21-04 01:54 PM
SOunds like you still need to bleed it. Installing a stainless clutch line introduces a lot of air...
|
3034, RE: NEED HELP ASAP!!!!
Posted by Sitinlo, Jun-21-04 06:10 PM
i flushed the system out and i have a strong petal. the clutch just isnt fully disengaging and i checked the master and slave cylinder and they arent leaking and the resivor is full
|