Welcome to the 2GNT Forum!
Home Site Background Info & Specs Mods & Tech Info CAPS Part Reviews Donate 2GNT Stickers
Search Printer-friendly copy 0 Users in Chat
Top 2GNT Technical Performance/Engine Manual Trans - NV-T350 topic #2776
View in linear mode

Subject: "Clutch Slipping .." Previous topic | Next topic
95redesiMay-14-04 11:56 AM
Member since Nov 25th 2003
328 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2776, "Clutch Slipping .."
May-14-04 12:08 PM by 95redesi

          

Ok my clutch is slipping ... again ..it did it awhile back then it stopped . Now its doing it again . What would cause it to do this ? Why would it the slipping get worse as I go higher through the gears. What clutch has everyone found works the best ?

Could this also be a case of bad tranny fluid ? what tranny fluid should i use? And for some odd reason I CAN NOT FIND out how to check my tranny fluid.. I dont see a dipstick or anything . Could someone tell me where it is ?

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Replies to this topic

TeamXtremeRSMay-14-04 03:14 PM
Member since May 20th 2003
6329 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2779, "RE: Clutch Slipping .."
In response to Reply # 0
May-14-04 03:15 PM by XtremeRS

          

Originally posted by 95redesi
Ok my clutch is slipping ... again ..it did it awhile back then it stopped . Now its doing it again . What would cause it to do this ? Why would it the slipping get worse as I go higher through the gears. What clutch has everyone found works the best ? Could this also be a case of bad tranny fluid ? what tranny fluid should i use? And for some odd reason I CAN NOT FIND out how to check my tranny fluid.. I dont see a dipstick or anything . Could someone tell me where it is ?


Clutch could be wore out, or oil could be getting on it, either from the transmission input shaft seal, or the motor's rear main seal. Your clutch hydrolics could be hanging up too, but that is less likely, but check your clutch master cylinder fulid level. It slips worse in a higher gear, because there is more torque needed to move the car in a higher gear ratio..There is no dipstick to check fluid level, but you have to get at the fill plug. Its a round, black rubber plug, on the driver side of the transmission. It will have a flat tab on it that you pull on to take it out. Once you get it out, stick your finger in the hole there, and the fluid should be level with the bottom of the fill hole. Its usually easiest to get at by jacking up the driver side, taking off the wheel, and getting under the car right there..Its kind of hidden, so look closely.


13.5 @108 MPH-2.2 60ft(stupid FWD!)
S16G @ 18 PSI/FMIC/Running on MegaSquirt II (Now with sequential
fuel injection)

My webpage: http://eclipsed4evr.home.comcast.net
-1998 Mitsubishi Eclipse RS-T- "Toy"
-1992 Plymouth Laser Turbo AWD(SOLD)
-2000 Honda CR-V(daily)

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

    
95redesiMay-15-04 08:55 AM
Member since Nov 25th 2003
328 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2788, "RE: Clutch Slipping .."
In response to Reply # 1


          

so i should be able to feel the fluid ? or i will be able to see it being level ? I dont quite get how you measure the fluid level .

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

        
JWoodleyMay-19-04 07:46 PM
Member since Mar 27th 2003
2335 posts,
Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2807, "RE: Clutch Slipping .."
In response to Reply # 2




          

make sure are your motor mounts/tranny brackets are not broken. my friend had a tranny mount work its way out on his 3000GT and when the motor torqued the clutch would slip because there was seperation between the motor and the tranny...not good.

  

Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Top 2GNT Technical Performance/Engine Manual Trans - NV-T350 topic #2776 Previous topic | Next topic
Powered by DCForum+ Version 2.2
Copyright 1997-2005 DCScripts.com, Copyright 2005-2026 2gnt.com
Generated in 0.022 seconds, executing 22 queries.