I have a leak I believe is coming from my tranny case. It's very slow. It's only about 1-2 drops per day, but still not good. I plan on dropping the engine to replace it this spring/summer, so I just want a temporary fix until I can rip apart the stupid case a reseal it correctly. Anybody think there would be any problems by putting silicon around the outside of the seal where I find the leak (if I find it)?

I can't see any problems with it, but thought I'd run it by you guys first to see if anybody knew a reason not to do this.

Thanks!
Matt

99GS MT | Star Stage 2 | GC coilovers | HurriganeGS tie bars | Tokico Illuminas | 17x7 Enkei RS5 | Baer track brakes |+

Go right ahead.

Make sure it's actually trans fluid. Could be motor oil from above.

_________________________________________
I'm the guy that bans you for breaking the rules. I am the troll killer. I am the law here.

I plan on cleaning the whole area really good and then driving it for a little bit to see if I can get a small bit of it out. Then I'll hopefully know a general location to apply the silicon.

Thanks!

99GS MT | Star Stage 2 | GC coilovers | HurriganeGS tie bars | Tokico Illuminas | 17x7 Enkei RS5 | Baer track brakes |+

jb weld will fix anything that and duck tape