Does anyone have an image or diagram of the bellhousing meeting up to the engine?

My eclipse has been down for about 6 months and I am finaly getting arround to fixing it but I can't remeber which bolts go where

Chilton is no help either.

All the black coarse thread M12's go between the block and trans. The ones with the tapered tip go from the block side (near the starter and on the back of the block) into the threaded holes in the bellhousing. The flat tipped bolts go from the trans side at the top (under the cam sensor and under the heater hoses) into the block.

Then there's the 8 crank -> flexplate bolts, and the 4 flexplate -> clutch bolts. All of those are short (i think) M10 bolts with 18mm heads.

______________________________
If a sentence found online has 35% misspellings or greater and includes at least two racially charged expletives, chances are it is a YouTube comment.

'95 Eclipse TurboGS (garage deco)
'95 TSi AWD (restoring a survivor)
'97 Talon ESi-T (poor impulse control)
'99 Eclipse RS-T (daily beater)
'13 Evo X (mostly stock)
'17 Sienna (Middle Aged Dad Mobile)



Factory Service Manuals: http://nawdu.de/files/