Welcome to the 2GNT Forum! Interested In Advertising with 2GNT?
Home | Site Background| Info&Specs| Mods & Tech Info | CAPS | Part Reviews | Donate | 2GNT Stickers |
Search Printer-friendly copy 1 User in Chat
Top 2GNT Technical Performance/Engine Manual Trans - NV-T350 topic #2499
View in linear mode

Subject: "Clutch Master Stage IV Question" Previous topic | Next topic
esseclipseMar-20-04 12:10 PM
Member since Aug 09th 2002
682 posts, 		Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2499, "Clutch Master Stage IV Question"




          

I just installed my built engine, Quaife LSD and Clutchmaster stage IV I also replaced the speedo gear, the two cone bearing that go on the diff and put in a new master and slave cylinder. When I start the car with the clutch in then release the clutch I hear a very slight buzz noise if I put the clutch in or just barly touch the petal the noise goes away.....anyone know what this could be?


  
Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Replies to this topic

WickedESiMar-20-04 09:43 PM
Donating 2GNT member
3090 posts, 		Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2500, "RE: Clutch Master Stage IV Question"
In response to Reply # 0



          

Did you put in a new release bearing?


Joel Baldridge, ASE Certified Master Technician, Audi Certified Expert Technician

  
Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

    
esseclipseMar-21-04 03:46 AM
Member since Aug 09th 2002
682 posts, 		Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2501, "RE: Clutch Master Stage IV Question"
In response to Reply # 1



          

Yup

  
Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

        
Moderator992gntMar-21-04 08:57 AM
Donating 2GNT member
2245 posts, 		Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2502, "RE: Clutch Master Stage IV Question"
In response to Reply # 2

          

I had the same setup, and it always made some noise.

Greg

'19 Genesis G70 3.3t AWD
'88 Chrysler Conquest TSI

  
Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

            
Super20GMar-21-04 06:50 PM
Old School 2GNTer
2545 posts, 		Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2503, "RE: Clutch Master Stage IV Question"
In response to Reply # 3

          

nope. no noise here. but my rear main is leaking :/ fck

  
Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

TeamMichael_97RSMar-22-04 05:40 AM
Donating 2GNT member
5866 posts, 		Click to send email to this author Click to send private message to this author Click to view this author's profile Click to add this author to your buddy list
#2504, "RE: Clutch Master Stage IV Question"
In response to Reply # 0

          

High stage clutches, are known to make chirping or chattering durign engagement and disengagement. A price to pay for high holding power.



Exile Racing Technologies: http://www.exileracing.com
una salus victus
It's holding down the garage floor right now.

  
Report This Post to Admin Printer-friendly copy | Reply | Reply with quote | Top

Top 2GNT Technical Performance/Engine Manual Trans - NV-T350 topic #2499 Previous topic | Next topic
   

Powered by DCForum+ Version 1.2
Copyright 1997-2003 DCScripts.com

I generated this page in 0.036345958709717 seconds, executing 14 queries.