Go back to previous topic |
Forum name | Manual Trans - NV-T350 |
Topic subject | Clutch Master Stage IV Question |
Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=34&topic_id=2499 |
2499, Clutch Master Stage IV Question Posted by esseclipse, Dec-31-69 06:00 PM
I just installed my built engine, Quaife LSD and Clutchmaster stage IV I also replaced the speedo gear, the two cone bearing that go on the diff and put in a new master and slave cylinder. When I start the car with the clutch in then release the clutch I hear a very slight buzz noise if I put the clutch in or just barly touch the petal the noise goes away.....anyone know what this could be?
|
2500, RE: Clutch Master Stage IV Question Posted by WickedESi, Dec-31-69 06:00 PM
Did you put in a new release bearing?
|
2501, RE: Clutch Master Stage IV Question Posted by esseclipse, Dec-31-69 06:00 PM
Yup
|
2502, RE: Clutch Master Stage IV Question Posted by 992gnt, Dec-31-69 06:00 PM
I had the same setup, and it always made some noise.
|
2503, RE: Clutch Master Stage IV Question Posted by Super20G, Dec-31-69 06:00 PM
nope. no noise here. but my rear main is leaking :/ fck
|
2504, RE: Clutch Master Stage IV Question Posted by Michael_97RS, Dec-31-69 06:00 PM
High stage clutches, are known to make chirping or chattering durign engagement and disengagement. A price to pay for high holding power.
Exile Racing Technologies: http://www.exileracing.com una salus victus It's holding down the garage floor right now.
|