|
you can break it down into two catigories, the wires on the headunit and the factory wires in the car. the color codes are as follows:
for the JVC: all speaker wires are in pairs with one color representing each speaker. in the colered pair, on will be solid and represents the positive wire, and the other will have a stripe (usually black) that represents the negative wire. the front right speaker is grey, the front left speaker is white, the rear right speaker is purple, and the rear left speaker is green.
for the power, the yellow wire is constant 12v+, the red is switched with the ignition 12v+, the black is grounded (on a side note, you will need to ground this yourself to the metel in the dash frame as there is no factory ground wire), and if you have a power antenna or amps, the blue wire is for that.
for the factory wires:
speakers right front: + is white w/ red stripe, - is blue w/ black stripe left front: + is white w/ blue stripe, - is black w/ blue stripe right rear: + is yellow w/ red stripe, - is grey w/ red stripe left rear: + is yellow w/ blue stripe, - is grey w/ blue stripe
power 12v+ constant (matches to yellow wire on JVC): red w/ black stripe 12v+ ignition: blue (located right next to the 12v+ constant on the harness)
now its time to just match everythng up and crimp away. of course, you could just go to best buy/circuit city/etc. and get a harness to crimp onto the headunit and then plug into the factory harness (assuming its not cut off). if you dont go the harness route, make sure to test it before you install it back into the dash 
:shhh: i do cocaine :/shhh:
|