#9037, "RE: Greddy EGT Probe Install" In response to In response to 2 Feb-20-05 10:00 AM by Vandy420a
Originally posted by Basikstylz but if I use the bolt and screw it in, then there is nothing holding the probe in. it slides right out of the fitting.
you need to use all of the pieces. Bascially screw in the piece that fits your tapped hole, then put in that washer piece, and screw in the probe with the smaller piece on top. It'll start off losse, but as you tighten it the washer piece crushes and tightens on the EGT probe. Its difficult to explain, but really not that hard to do. Just remember it starts out loose, but tightens on the probe as you screw in the 2nd part.
---------------------------------------
Black 98 GST missing her owner and looking for a new one...Inquiries welcome
