Ok, well I guess I'm going to just start over. My buddy says he's got the adaptor what not needed to make the double flares. I'm going to order the same lines as I have now just because I know the female ends are pretty stripped. -3 line, 10mm x 1 male and 10mm x 1 female end, 20".

Now the part I'm curious about is the fittings to get.
http://www.anplumbing.com/shop/index.php?shop=&dept=Speed-Seal-Steel
At the bottom of the page, Special Brake Hose Ends - Male. Do I get the 640303 or 640803? The difference is convex (inverted flare) or long concave

I'll cut off what's on there now. Take my new fittings, slide them up the line, do the double flare like it should, then seal the fittings and new ss lines together

-Xavier-
95 Eclipse RS-T...lost in the frozen tundra