#18229, "RE: Bad Camber... Pics, any ideas??" In response to In response to 15
Been there Done that...
I eventualy got rid of the 8 washers & found some aluminum stock about the same thickness. Cut it into squares just biger than the washers & drilled bolt holes in. They are much more stable than the washer buisness, and the bolts I got from PepBoys are about 2 inches long so plenty of hold there too.
The toe was still out and killed my rubber though, but before you get it aligned again have your exsisting tires rotated off the rims so you have the good tread inside. Then go get your toe fixed and you'll still be run'n on the best part of your tires you have left:thumbsup