Ok... With front I was going to use spacers due to the fact I dont need to bring them out as far as back. With the back though Im pretty sure no one makes 6 inch spacers. With the back I know offset would be crazy trying to get them out there... What I am looking at is something like this:

1: Take rear cross over (or whatever its called.)


2. Cut in half. Extend 12 inches. Use 1/4 steel sheet to extend and bolt and weld on.


3. Since the bolt holes well no longer match up under frame, use 1/4 inch angle to bolt from side to side and then make new bolt holes to bolt up


4. Theres the horse shoe shaped thing that well also need to come out. Have a shop make me spacers like so.


5. As well as shock well need an extender made.


I know there well be clearence issues that I well need to fabricate and modify here and there. And I know I am a hell of an artist. Let me know your concerns or suggestions on this