#4610, "RE: 034 EFI Controller Wiring Question" In response to In response to 6
That one was for the old style 034 controller, I needed to know for the newer style. To do my part to contribute I will post this:
You dont have a HALL, so you can disregard all those.
6 and 7 go to the 12V supply of the injector harness, you'll see they are paired, inj 1 with inj 3, inj 2 with in 4)
8 is the pwr for the controller, tie it into a source that comes on with the key
9 and 10 go to grounds of the injector harness, make sure ground 9 goes to same injectors as 12v pin 6, and grnd 10 goes to same injectors as 12v pin 7
15 is looking for revs, the old controller we tied this into the tach wire off the ecu... from that descrip looks like you can tie into a grnd wire of the stock injector harness maybe? dunno, someone with a new controller throw in ur 2 cents here, mine is the old orig controller from like 6 years ago
16 to chassis ground
I used these instructions to completely re-do my wire harness and it all worked just right!
