Ok so I bought a used 034 went to install it last night and could NOT figure out the disaster of a wiring harness the guy sent me!! I'm in a bind here and need someones help bad! I got a guy who's willing to help me make an entirely new harness this afternoon but I want to make sure that this picture IS correct? Maybe someone could tell me where each pin goes?
I've read Corbins write up and just about every thread there is on the controller and I'm still stuck.
I'd really appreciate ANY help!
Thanks!



Here's the ghetto-wired harness I got!

yikes. i'd contact the manufacturer first. who builds it? splitsecond?

034 Motorsports. It's the secondary injector controller

Nevermind, I found it!

excellent. knew you would. good luck.

What was the answer? Others may find this thread in a search and if that pic is correct it seems like it'll be very useful

Originally posted by Mike431635
What was the answer? Others may find this thread in a search and if that pic is correct it seems like it'll be very useful

Everything is in the wiki.

http://www.2gnt.com/index.php?d=Building_an_8_Injector_Fuel_System

It's much simpler than the the picture in the first post led one to believe.



Also moved to the proper section.

That one was for the old style 034 controller, I needed to know for the newer style. To do my part to contribute I will post this:



You dont have a HALL, so you can disregard all those.

6 and 7 go to the 12V supply of the injector harness, you'll see they are paired, inj 1 with inj 3, inj 2 with in 4)

8 is the pwr for the controller, tie it into a source that comes on with the key

9 and 10 go to grounds of the injector harness, make sure ground 9 goes to same injectors as 12v pin 6, and grnd 10 goes to same injectors as 12v pin 7

15 is looking for revs, the old controller we tied this into the tach wire off the ecu... from that descrip looks like you can tie into a grnd wire of the stock injector harness maybe? dunno, someone with a new controller throw in ur 2 cents here, mine is the old orig controller from like 6 years ago

16 to chassis ground


I used these instructions to completely re-do my wire harness and it all worked just right!