I've got my MS unit and i got everything connected. Yehhaaa.
After overcoming a small miswire in my relay, i got power to the MS unit and my computer immediately found it. Even with a DB-9 to USB bridge being used. Well, i booted up the different versions of Megatune that i have (3 different MS1 megatune programs) and each one said that the firmware i was running was different from the control.
The exact error message was this...
Controller code version does not match signature in MSnS-extra.ini. (See audit.log for where the above file was found.)
Expected “MS1/extra format 029y3 **********” (found in the ini file) Received “0x53” (from controller)
Table corruption may occur, this is usually a very serious problem.
Terminate Mega tune now? Yes/no
I searched the MS1extra forum and came back with nothing. Looking for some assistance. I'm working on it too, but the more brains the better.