Well after over an hour of searching I found a bad ass pic of how the brackets go on and what they hold. I did not know how the diff pin was in there and that was the part that I was confused about. It runs perpindicular to the gears and brackets. Now I need to cut off 1/2 inch from the top of these brackets right? Now is this exactly 1/2 inch because I had to order these and do not want to come up short of the diff pin. Then I will have to order more brackets and leave the car apart even longer. Let me know if it is exactly 1/2 inch and I will cut it tomarrow thanks once again you all are a big help! Patrick 96 GS 14.14 @ 96.5 mph on 8psi 8 Nov.02 HRC kit, S20G, FMIC, Howell bottom end 8.6 pistons, S-FMU, Blitz BOV, P&P head, SS valves, lots more little goodies